6–2
CONTROLLER BASIC
PROGRAMMING
Normal Operating Mode
Check oil level before
turning cook/filter switch
to COOK.
Action: Turn cook/filter switch to
COOK.
Response: Temp Display alternates
between number values for cook tem-
perature, and LO (idle mode). LO dis-
appears when oil temperature reaches
cook temperature value. Time Display
shows the set time in minutes and
seconds.
Set Temperature
Action: Press Cook Temperature But-
ton twice within 5 seconds.
Response: Programming mode has
been entered. Flashing Temp Display
reads “###F” (where ### = tempera-
ture value, such as 360°F).
Action: If desired, press keypad num-
bers to change displayed value. Press
Cook Temperature Button once to
enter new value into memory.
Response: Controller returns to idle
mode.
Set Time
Action: Press Cook Time Button twice
within 5 seconds.
Response: Programming mode has
been entered. Flashing Time Display
reads “##:##.” (##:## = time value in
minutes:seconds, such as 08:00).
Action: If desired, press keypad num-
bers to change displayed value in min-
utes and seconds. Press Cook Time
Button once to enter new value into
memory.
Response: Controller returns to idle
mode.
Set AUTO COMP (Automatic Time Com-
pensation)
Action: Press and hold AUTO COMP
Button for 3 seconds.
Response: Green light will toggle on
or off.
Reset Cycle Counter
Action: Press Reset Button twice in
5 seconds.
Response: Display returns to a setting
of “00.”
If counter is not reset
before reaching “99,”
upon the next cycle completion, the
display will begin counting at “01.”
Normal operating programming can be
done at any time without affecting presets.
broaster.com Manual #15459 5/02 Rev: 6/16
To Next Page
Loading...
