FIGURE 5 Attaching the adhesive feet
1. Attach the four adhesive feet to the bottom of the device.
2. Set the device on a at desktop, table, or shelf near an AC power source. Make sure that adequate ventilation is provided for the
system. A 7.62 cm (3-inch) clearance is recommended on each side.
3. If installing a single device only, go to the “Powering on the system” task. If installing multiple devices, place each device
squarely on top of the one below.
4. If installing multiple devices, attach the adhesive feet to each device.
Rack mount installation
The devices use stationary mounting when mounted in a rack. The rack-mount kit is not included with the device and is available to order
separately.
DANGER
Make sure the rack housing the device is adequately secured to prevent it from becoming unstable or falling over.
Installing the device
Brocade ICX 6430-C Compact Switch Hardware Installation Guide
Part Number: 53-1003618-02 23