5
• BREAKDOWN O
• BREAKDOWN O• BREAKDOWN O
• BREAKDOWN ON THE SMOKE
N THE SMOKE N THE SMOKE
N THE SMOKE VACUUM CLEANER
VACUUM CLEANERVACUUM CLEANER
VACUUM CLEANER
If the extractor stops, the electronic card blocks automatically the pellet fuel supply.
• BREA
• BREA• BREA
• BREAKDOWN O
KDOWN OKDOWN O
KDOWN ON THE PELLET FUEL LOADING ENGINE
N THE PELLET FUEL LOADING ENGINEN THE PELLET FUEL LOADING ENGINE
N THE PELLET FUEL LOADING ENGINE
If the differential engine stops, the heater keeps on working until it does not reach the minimal functioning
temperature and stops.
•
• •
• ELECTRICAL
ELECTRICAL ELECTRICAL
ELECTRICAL CURRENT
CURRENTCURRENT
CURRENT
TEMPORARY FAILURE
TEMPORARY FAILURETEMPORARY FAILURE
TEMPORARY FAILURE
After a brief absence of current, the heater turns on again. When electricity is missing, the heater can produce
a limited quantity of smoke inside the house during an interval from 3 until 5 minutes. THIS DOES NOT
THIS DOES NOT THIS DOES NOT
THIS DOES NOT
ENDURE ANY RISK FOR THE SAFETY
ENDURE ANY RISK FOR THE SAFETYENDURE ANY RISK FOR THE SAFETY
ENDURE ANY RISK FOR THE SAFETY. That’s why Bronpi advises whenever it is possible to connect the pipe of
entry of primary air with the exterior of the housing to ensure that the heater could not detach smokes after
the above mentioned absence of current.
• ELECTRICAL PROTECTION
• ELECTRICAL PROTECTION• ELECTRICAL PROTECTION
• ELECTRICAL PROTECTION
The heater is protected against sudden electricity oscillations by means of a general fuse placed on the back
part. (2nd 250V Slowed down). (To see photo 1).
•
• •
• EXIT SMOKE
EXIT SMOKE EXIT SMOKE
EXIT SMOKE PROTECTION
PROTECTIONPROTECTION
PROTECTION
An electronic pressureswitch foresees to block the operation of the heater, if sudden change of pressure takes
place inside the combustion chamber (door opening, damage of engine of smokes extraction…) the heater
will go into the alarm mode. (Photo 2)
• PROTECTION BEFORE
• PROTECTION BEFORE • PROTECTION BEFORE
• PROTECTION BEFORE THE PELLET
THE PELLET THE PELLET
THE PELLET HIGH TEMPERATURE (80th C)
HIGH TEMPERATURE (80th C)HIGH TEMPERATURE (80th C)
HIGH TEMPERATURE (80th C)
In case of overheating inside the hopper, this device blocks the appliance operation. The manual
reestablishment must be carried out by an authorized technician. (Photo 3).
The reestablishment of this
The reestablishment of thisThe reestablishment of this
The reestablishment of this
safety device
safety devicesafety device
safety device
is not considered by
is not considered byis not considered by
is not considered by
the warranty, unless the
the warranty, unless thethe warranty, unless the
the warranty, unless the
assistance
assistanceassistance
assistance
centre
centrecentre
centre
may
may may
may
demonstrate the presence of a defective component.
demonstrate the presence of a defective component.demonstrate the presence of a defective component.
demonstrate the presence of a defective component.
Picture 1 Picture 2 Picture 3
4
44
4 TECHNICAL
TECHNICAL TECHNICAL
TECHNICAL FEATURES
FEATURESFEATURES
FEATURES
Features
FeaturesFeatures
Features
To Next Page
Loading...