C-15
Model 0254
Section C Serial Communications Protocol
Installation and Operation Manual
X-SE-0254-eng
Part Number: 541B129AAG
September, 2010
Blend Command
This command is used to select a blend master channel and thereafter
start the desired blending operation. At least one, or more, slaves output
rates are controlled to be a proportion of the selected masters delivery
rate.
The qualified channel output port must have its [Control Function] set to
[Blend].
The required master channel input port is specified in the start command
by inserting its port sub-address [.xx] in the command, and must be one of
the following:
Channel Sub-Address
11
23
35
47
HOST SEND
AZ[.xx] B<cr> Start blending
AZ F<cr> Stop blending
RESPONSE - none
To Next Page
Loading...
