19 | ENBrose Display Allround E41230 // Operation and control
Operation and control
15 Switching the Brose Drive System on and off
INFORMATION
· The Brose Drive System can only be
started up with a sufficiently charged
battery (at least one white charging
bar visible).
· Depending on the battery installed
in your e-bike, it may take a few
moments for the display of the control
unit to turn on.
Activation
· With the e-bike battery inserted, press
the button on the control unit once.
› The Brose Drive System is now
ready for operation.
The drive is activated as soon as
you start pedaling. The motor power
depends on the assistance level set on
the control unit.
As soon as you stop pedaling in normal
mode or as soon as you reach a speed
of 25 km/h, the assistance function of
the e-bike drive is switched off.
The drive is automatically reactivated
as soon as you start pedaling and the
speed is below 25 km/h.
Deactivation
· Press the button on the control unit
for at least 1.5 seconds.
› The system takes about 3 seconds
to turn off completely. You can turn
on the system again only after it has
shut down completely.
The control unit, drive unit and battery
are switched off completely.
Automatic deactivation
If no power is called up from the e-bike
drive for approx. 15 minutes (e.g.
because the e-bike is stationary) and no
button is pressed on the e-bike control
unit, the Brose Drive System switches
off automatically to save energy.
The time after which the control unit
switches off automatically can be
adjusted in the settings
(see chap. 24 on
page 26)
.
The control and display unit is always
switched on, even if the motor assistance
is deactivated.
Always switch off the Brose Drive
System when you park the e-bike.
To Next Page
Loading...
