To Next Page
D
Denise WelchAug 7, 2025
What to do if the LED band of Brose Bicycle Accessories control unit shows an error?
- DDavid HunterAug 7, 2025
An active error exists within the system. Please refer to Chapter 27, 'Error displays,' for guidance.
What to do if the LED band of Brose Bicycle Accessories control unit shows an error?
An active error exists within the system. Please refer to Chapter 27, 'Error displays,' for guidance.
What to do if Brose Display Remote Bicycle Accessories control unit doesn't show trip data?
Check the magnet's placement, paying special attention to its distance from the speed sensor on the chainstay. Ensure the gap is between 5 and 17 mm, adjusting as needed.
How to fix Brose Bicycle Accessories lighting that cannot be activated?
The lighting may not activate if the cable is incorrectly connected. Inspect the wiring and plug connections, and correct them if necessary.
What to do if the Brose Display Remote battery is not correctly engaged?
If the battery isn't correctly engaged, remove it and reinsert it, ensuring it fits properly. Also, fully charge the battery. Check all contacts are clean; if needed, clean them with a soft, dry cloth. Finally, check the plug connection of the control unit, making sure it fits correctly and that all contacts are clean; clean with a soft, dry cloth if necessary.
General| Brand | Brose |
|---|---|
| Model | Display Remote |
| Category | Bicycle Accessories |
| Language | English |
Lists all original operating instructions for the Brose Drive System components.
Emphasizes careful reading and retention of instructions for safe use.
Describes the purpose and intended application of the components.
Warns against tampering, tuning, and unauthorized modifications.
Highlights unavoidable risks associated with e-bike use.
Provides a brief overview of the remote control unit.
Shows the remote and display unit together.
Details the function of each button on the remote.
Guides on how to install and position the remote.
Shows the main display unit and its components.
Guides on how to install and position the display.
Describes basic safety notices and action-related warnings.
Explains the signal words and warning symbols used.
Details how safety notices are graded by hazard level.
Step-by-step guide for remote installation.
Fine-tuning the position of the remote control.
Step-by-step guide for display unit installation.
Fine-tuning the position of the display unit.
Details the indicators on the remote control unit.
Explains the information presented on the main display.
Focuses on the user interface of the central display.
Instructions for powering the system on and off.
Selecting support levels using the remote.
Selecting support levels via the central display.
Details the characteristics of each support mode.
How to turn lights on and off directly.
Setting up auto light functions.
Customizing displayed ride data.
Displays technical details about the Brose Drive System.
Battery status on the remote control.
Battery status on the central display.
Overview of the main menu options available.
General settings for the display and system.
Specific configurations for lighting, units, clock, etc.
General advice for diagnosing problems.
How error messages are shown on the units.
Specific error codes for the remote control.
Specific error codes for the central display.
Precautions for transporting the e-bike and its components.
Recommendations for regular checks and servicing.
Instructions on how to clean the components safely.
Technical specifications of the remote.
Technical specifications of the display.
Statement of compliance with EU directives.
How to get help and contact Brose.
Legal information regarding the manual's content.
