25 | DEDisplay Remote // Display Central // Operation and handling
Operation and handling
15 Switching the Brose Drive System on and off
INFORMATION
∙ The Brose Drive System can only be
operated with a sufficiently charged
battery (at least one white charging
bar visible).
∙ Depending on the battery installed
in your e-bike, it may take a few
moments for the control unit display
to switch on.
Switching on
∙ With the e-bike battery pack inserted,
press the button on the control
unit.
› The Brose Drive System is now
ready for operation.
The drive is activated as soon as
you start pedalling. The motor power
depends on the support level set on the
control unit.
As soon as you stop pedalling in normal
mode or as soon as you have reached a
speed of 25 km/h, the support from the
e-bike drive is switched off.
The drive is automatically re-engaged
as soon as you start pedalling and the
speed is below 25 km/h.
Switching off
∙ Press the button on the control unit
for at least 1.5 seconds.
› The Brose Drive System takes
about three seconds to switch off
completely. You can only switch it
on again after it has completely shut
down.
The control unit, display unit, drive unit
and battery are switched off completely.
Automatic switch-off
If no power is called from the e-bike
drive for approx. 15 minutes (e.g.
because the e-bike is stationary) and no
button is pressed on the e-bike control
unit, the Brose Drive System switches
off automatically to save energy.
The time after which the display unit
switches off automatically can be
adjusted in the settings
(see chap. 25 on
page 34)
.
The control unit is always switched on
even if the motor support is deactivated.
Always switch off the Brose Drive
System when you park the e-bike.
To Next Page
Loading...
