Brose Display Remote - System settings

DE | 34 Menu and settings // Display Remote // Display Central
25 System settings
Light
Battery Status
Clock
Unitformat km
Timeformat 24h
Custom. Assistance
Default Settings
Shutdown Time
11:59
SYSTEM
BACK
Fig. 11: SYSTEM Menu
Call SYSTEM.
∙ Press the  button for two seconds.
∙ Use the  /  buttons to select
Settings and confirm the selection
with the  button.
∙ With the / button, select System
and confirm the selection with the
button.
→ SYSTEM is shown on the display.
On the SYSTEM menu, the following
settings and information are available for
selection:
Light
∙ Settings for the lighting (only if the
lighting is powered by the Brose Drive
System).
› The lighting is switched on and off
automatically.
› Switch on the lighting permanently.
Unitformat
∙ Unit selection:
(km/mi) / (km/h/mph).
Timeformat
∙ Select the time format(12h/24h).
Battery Status
∙ Battery display as segments.
∙ Battery display in percent (%).
∙ Plain Design:
Display in percentage (%) and
segments.
Clock
∙ Setting the time
› Press the  button. The hour
indicator flashes.
› Set the desired hour with the /
buttons.
› Confirm your entry with the
 button. The minute display
flashes.
› Set the desired minute with the
/ buttons.
› Confirm your entry with the
button.
Shutdown Time
∙ Define the automatic switch-off time
(1-20 minutes) of your Brose Drive
System.
Custom.Assistance
∙ Adjust the support levels individually
to your needs.
Default Settings
∙ After confirming again, all settings are
reset to the delivery state.