DE | 20 Before the rst commissioning // Display Remote // Display Central
Before the first commissioning
WARNING
Risk of accident and injury!
If you are distracted by the operation or
displays on the control or display unit
while cycling, this distraction can result
in accidents and serious injuries.
» Familiarise yourself with the functions
and handling of the control and
display unit away from road traffic
before using your e-bike for the first
time.
NOTE
Risk of damage!
Improper handling can cause
damage to the control unit or the
display unit.
» Never twist the fixed control or
display unit. Always loosen the
respective fastening screw before
turning the operating or display unit
to adjust it.
The commissioning of the control or
display unit does not require any further
steps after installation.
The control and display units are ready
for operation as soon as they have been
connected correctly and the battery is
sufficiently charged.
∙ You can control the functions of
your Brose Drive System with the
operating elements (buttons) on the
control unit.
∙ The control unit display informs you
of the selected support level, as well
as other information about your Brose
Drive System.
INFORMATION
∙ The control and display units do
not have their own battery and can
therefore not be used or operated
outside the e-bike.
∙ If the e-bike is switched on, the
control and display unit always remain
switched on during cycling; even if
the motor support is deactivated.
INFORMATION
Full function is provided only if the
speed sensor and all cables have been
connected correctly and the battery is
charged (at least one white charging
bar visible).
INFORMATION
∙ The menu and settings cannot be
accessed during cycling.
∙ All interface representations and
interface texts on the following pages
correspond to the release status of
the software.
∙ An update may change the display
slightly; you can obtain any updates
from your authorised Brose dealer.
To Next Page
Loading...
