Brose E41230 - Assembly and Adjustment

13 | ENBrose Display Allround E41230 // Assembly and adjustment
Assembly and adjustment

WARNING
Risk of accidents and injury!
Incorrect or improper assembly and
maintenance work can damage
your e-bike or the components and
increase the risk of accidents.
» Do not overestimate your technical
abilities.
» Have assembly and maintenance
work, in particular the replacement of
components and spare parts, carried
out only by an authorized Brose
specialist dealer.
» Do not under any circumstances
carry out any work or make any
changes to your e-bike or the
components if you do not have the
necessary expertise and required
tools.
» Always switch off the Brose Drive
System and remove the battery
before starting work.
» Make sure that you can safely operate
the controls on the handlebars at all
times.
NOTE
Risk of damage!
Improper handling can cause
damage to the control unit.
» Never twist the fixed control unit.
Always loosen the grub screw before
turning the control unit to adjust it.

INFORMATION
· The control unit can be mounted
on either the left or right side of the
handlebar.
· Brose recommends positioning on
the left-hand side of the handlebar.