Brose E41230 - 26 Error Indication in the Display

EN | 28 Error handling // Brose Display Allround E41230
26 Error indication in the display
The control unit displays error messages
of the entire Brose Drive System.
Depending on the type of fault, the
drive may be switched off automatically.
Check the e-bike before further rides.
Continuing to drive without assistance
from the drive is possible at any time.
The error display can indicate serious
faults in your Brose Drive System.
· Stop the ride. Find out the meaning of
the error indication and observe the
solution approach.
· If the meaning of the notice is unclear,
turn off the e-bike. Contact the e-bike
manufacturer or an authorized Brose
dealer for information on the next
steps.
Indication in display Remedy
Check Speed Sensor
Switch off the Brose Drive System.
Check the speed sensor and position of the
magnet.
Restart the Brose Drive System.
Check Light
Switch off the Brose Drive System.
Check all wires and plug-in connections of the
front and/or rear lighting system.
Restart the Brose Drive System.
Restart System
Restart the Brose Drive System.
If the problem persists, please contact an
authorized Brose dealer.
Check Brake Light
Switch off the Brose Drive System.
Check all lines and plug-in connections of the
brake system.
Restart the Brose Drive System.