Brother BAS-415 - Page 127

When an error message is displayed, refer to the instructions below.
<List of error messages 3 >
Message in comm,unication
Cause
·· mode'
Can't communi
1.
Paper tape reader or editing
system does not connect with
machine by cable.
2.
Power of paper tape reader or
editing system is not turned
on.
3.
Editing system does not enter
communication mode.
4.
Editing system is
communicating with another
machine.
Communicate ERR.
1.
Data error occurs during
communicating with editing
system.
2.
Editing system exits from
communication mode while
machine is communicating
with editing system.
3.
Power of editing system is
turned off during
communicating with editing
system.
Edit-Sy. busy
Editing system
is defective, or
breakdown.
Tape read
ERR 1.
Poor punch of paper tape
2. Paper tape runs short.
3. Dirty head of paper tape
reader
4.
Power of paper tape reader is
not turned on.
5.
Paper tape type is wrongly
selected.
6. Improper communication baud
rate
Message in replacing
Cause
needle bar
N. Case POS. ERR
1. Needle bar case is not set
properly.
2.
Damaged circuit board
N. Case locked
1.
Needle bar case is too tight
mechanically, or locked and
cannot move.
2.
Electrical failure
-124-
Solution
Link with exclusive cable.
Turn
on power.
Set editing system to
communication mode.
Wait till communication ends.
Re-communicate.
Set editing system to
communication mode, then
communicate again.
Turn on
power of editing system
again,
enter communication mode.
Turn
on power of editing system
again,
enter communication mode.
Contact your dealer.
Remake paper tape.
Clean head.
Turn
on power.
Select proper
type to read paper
tape.
Adjust baud rate.
Solution
Position needle bar case properly.
Contact your dealer.
Remove load.
Contact your dealer.
From the library of: Superior Sewing Machine & Supply LLC