98
Turning off the machine will erase the fax data in the memory. To prevent you from losing any
important messages, see Transferring your faxes or Fax Journal report (MFC models)
on page 109.
Self-Diagnostic The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
Turn the machine off, wait a few seconds, and
then turn it on again. Leave the machine idle for
15 minutes with the power on.
The fuser unit is too hot.
Size mismatch The paper in the tray is not the
correct size.
Load the correct size of paper in the tray and
set the size of paper to the tray.
Toner Low If the LCD shows Toner Low
you can still print; however, the
machine is telling you that the
toner cartridge is near the end
of its life.
Order a new Brother toner cartridge now so a
replacement toner cartridge will be available
when the LCD shows Replace Toner or
Toner Ended.
Error Message Cause Action
To Next Page
Loading...
