Brother DCP-1601

General information
15
1
4.Dial Tone
3.Dial Tone
(for New
Zealand)
— You can shorten the
dial tone detect
pause.
Detection Your machine will
dial as soon as it
detects a dial tone.
No Detection* When you send a fax
automatically, by
default your machine
will wait for a fixed
amount of time
before it starts to dial
the number.
5.Dial Prefix
4.Dial Prefix
(for New
Zealand)
— Sets a prefix number
that will always be
added before the fax
number every time
you dial.
— Enter the prefix
number (up to 5
digits) on the dial
pad, and then press
OK.
The dial prefix setting
will automatically dial
a predefined number
before every fax
number you dial. For
example: If your
phone system
requires a 9 to dial an
outside number this
setting will
automatically dial 9
for every fax you
send.
6.Reset
5.Reset
(for New
Zealand)
1.Machine
Reset
Restores all the
function settings to
factory default.
1.Reset
2.Exit Cancel restore and
exit the menu.
2.Network Restores all network
settings to the factory
default.
1.Reset
2.Exit Cancel restore and
exit the menu.
3.Address &
Fax
Restores all stored
phone numbers and
fax settings.
1.Reset
2.Exit Cancel restore and
exit the menu.
4.All
Settings
Restores all the
machine settings to
factory default.
All Settings takes
less time than
Factory Reset.
1.Reset
2.Exit Cancel restore and
exit the menu.
0.Initial Setup (For MFC-1910W, MFC-1911NW and MFC-1916NW) (continued)
Level 2 Level 3 Descriptions 1 Options Descriptions 2 Page
The factory settings are shown in Bold with an asterisk.