244
Troubleshooting
Printed surface cracks after fixation
Probable Cause Remedy
Isn't the print surface folded before fixation is
completed?
Try not to touch the print surface until the fixation process is
completed.
The lower left side area of the printer's main unit is soiled with ink
Probable Cause Remedy
Is the waste ink tube dismounted from the
maintenance unit?
For help, please contact your dealer.
The cleaning solution is leaked from the cleaning liquid tank
Probable Cause Remedy
Is the main body of printer put aslant? With reference to "4-1. Installation of printer >>P.39", place the
printer horizontally level.
If the problem is still not remedied, please contact your dealer.
Takes longer print time than before
Probable Cause Remedy
Is the ambient temperature under 18°C (64.4°F)? Adjust the room temperature to 18°C (64.4°F) or more.
If it is difficult to adjust the room temperature, refer to "8-5. Print
Operation Settings Under Low Temperature >>P.227" to [Disable]
the operational configuration under low temperature.
To Next Page
Loading...
