273
Troubleshooting
(13) Remove each tube from the print head to be replaced with a new one, then attach each of the new caps which are
removed from a new print head to each tube, while exercising care to prevent any ink from being spilled.
<IMPORTANT>
Care is needed in preventing any ink from being spilled from each tube.
Be careful not to confuse it with the tube for the print head on the color side.
Be sure not to tighten the nut for part (a) by mistake. It could remove the tube and leak the contained ink.
When you replace the print head, be sure to move the carriage manually to the position of the platen at the center of the
printer before starting the replacement. If you perform the mounting of the head when the carriage is directly above the
maintenance unit, it may damage the maintenance unit or the heads.
<NOTE>
For a proper work operation, be sure to wear the printer-provided gloves.
X013
(14) Remove the resin cover which is placed on the top of the carriage board carriage board.
(15) Open the hold-down clip for cable, and remove the flat cable.
X013
Tube
Cap
Tube
Resin cover
Flat cable
Hold-down clip for cable
(a)
To Next Page
Loading...
