Brother GTX-4 - Page 285

285
Troubleshooting
(10) Place the spring under the wiper on the maintenance unit latch.
X015
2
(11) Insert a wiper cleaner into the printer from above, tip it leftward and put it in place.
<TIPS>
 During this process, it is recommended to also replace the wiper cleaner with a new one.
 First, insert the shaft from above. Then fold it to the left, press the area with the PUSH indication until a clicking sound is
heard, and get the latch into position.
X0056
Wiper cleaner
Shaft
Shaft
Wiper
Spring
Latch
Latch
Latch