Brother HL-L9300CDW - Page 266

3-125
Confidential
(18) Turn the LT frame L unit right side up.
(19) Remove the two Taptite cup S M3x6 SR screws from the LT beam rear.
Fig. 3-178
(20) Remove the two Taptite cup S M3x6 SR screws from the LT beam rear.
Fig. 3-179
LT beam rear
Taptite cup S M3x6 SR
<Back side>
Taptite cup S M3x6 SR
LT beam rear
<Left side>