Brother HL-L9300CDW - Page 372

7-23
Confidential
(18) Remove the six Taptite bind B M4x12 screws and four Taptite cup S M3x6 SR screws,
and remove the Scanner cover plate from the Main body.
Fig. 7-37
(19) Disconnect the Laser unit flat cable from the Laser unit and release the wiring.
Fig. 7-38
Assembling Note:
When assembling the six screws of the Taptite bind B M4x12, be sure to assemble them in
the order shown in the figure.
Taptite bind B M4x12
Taptite cup S M3x6 SR
Main body
1
2
3
4
5
6
Taptite cup S M3x6 SR
Taptite cup S
M3x6 SR
Taptite bind B M4x12
Taptite bind B M4x12
Taptite bind
B M4x12
Scanner cover plate
<Front side>
Laser unit
CN1
Laser unit flat cable
<Front side>