Brother HL-L9300CDW - Page 373

7-24
Confidential
(20) Remove the five Taptite cup S M3x6 SR screws and remove the four Scanner holders
from the Scanner plate.
Fig. 7-39
Fig. 7-40
Assembling Note:
- When assembling the Scanner holder to “A” of the Laser unit, be sure to use the Scanner
holder of which “B” is a screw and not to use other Scanner holders.
- When assembling the Scanner holder to “A” of the Laser unit, be sure that the Scanner
holder is placed as shown in the figure.
Taptite cup S M3x6 SR
Taptite cup S M3x6 SR
Taptite cup S M3x6 SR
Taptite cup S M3x6 SR
Taptite cup S M3x6 SR
Scanner holder
Scanner plate
Scanner holder
Scanner holder
Scanner holder
<Front side>
“B”
“A”
Laser unit
Scanner holder
Scanner holder
Laser unit
<Front side>