2-30
Confidential
Unable to
Update
Press Stop.Wait
until Ready state
and try again.
Execution of the program update
cannot be started because other
function is being executed.
--- 4.11.3
Unusable
Device
-
An USB device that did not meet
the specifications was inserted
into the USB port.
--- 4.11.2
Remove the
Device. Turn the
power off and back
on again.
Overcurrent was caused
because a USB device that did
not meet the specifications was
inserted into the USB port.
EC00 2-83
Unusable
File
Press Stop.Check
the firmware file in
the device and try
again.
The update process cannot be
continued because the data of
the program file is incorrect.
--- 4.11.1
WT Box End
Soon
-
The waste toner sensor detected
that the waste toner box is almost
full.
4700 2-51
2-sided
Disabled
Close the Back
Cover of the
machine.
The back cover sensor detected
the open state when 2-sided
printing is started.
(before the registration of printing
in the engine)
8903 2-69
The back cover sensor detected
the open state during 2-sided
printing. (after the registration of
printing in the engine)
8904 2-69
Load #S paper and
press Go.
The registration rear sensor
detected that the length of the
paper is too long and it may hit
within the machine in 2-sided
printing.
8A02 2-69
Error Message
State
Error
Codes
Refer
to:
1st line 2nd line
To Next Page
Loading...
