Network Scanning (For models with built-in network support)
112
4
How to set a new default for Scan to FTP 4
You can set your own default settings for Quality, File Type, Glass ScanSize and File Name.
Setting the new default 4
a Press the (Scan) key.
b Press a or b to choose Scan to FTP.
Press OK.
c Press a or b to choose Manual.
Press OK.
Note
If there is no FTP Profile configured, skip c and go to d.
d Enter the FTP host address (for example ftp.example.com up to 60 characters) or the IP address (for
example 192.23.56.189).
Press OK.
e Enter the destination folder (for example /brother/abc/, up to 60 characters).
Press OK.
f Enter Username. Press OK.
g Enter Password. Press OK.
h Press and choose your new setting. Repeat this step for each setting you want to change.
i After changing the last setting, press a or b to choose Set New Default.
Press OK.
j Press 1 to choose Yes.
k Press Stop/Exit.
To Next Page
Loading...
