Wireless Configuration for Macintosh using the Brother installer application (For DCP-373CW, DCP-375CW, DCP-377CW,
DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)
79
5
n Check the printed Network Configuration page. Choose the status as it is shown for the
Wireless Link Status on the Network Configuration page.
Click Next. If your status is "Link OK.", go to step p.
If your status is "Failed To Associate", go to step o.
Note
If you are using WEP and your status is "Link OK." but your machine is not found, make sure you entered
the WEP key correctly. The WEP key is case sensitive.
o Click Finish. Wireless setup failed as it was unable to associate with a wireless network. This is probably
due to incorrect security settings. Reset the print server back to its factory default settings. (See
Restoring the network settings to factory default on page 114.) Confirm the security settings of your
wireless network and try starting from step d again.
To Next Page
Loading...
Need help?
General
