Control panel setup
22
3
DNS Server 3
a Press Menu.
b Press a or b to select LAN.
Press OK.
c Press a or b to select TCP/IP.
Press OK.
d Press a or b to select DNS Server.
Press OK.
e Press a or b to select Primary or Secondary.
Press OK.
f Press a or b to select Change.
Press OK.
(For MFC-680CN) Skip to step g.
g Enter the DNS Server address.
Press OK.
Note
For DCP models, press a or b repeatedly to enter the first three-digit number for the DNS Server address.
Press c to enter the second three-digit number. Repeat this step until you have entered the fourth three-
digit number to complete the DNS Server address. Press OK.
h Press Stop/Exit.
Primary DNS Server IP Address
3
This field specifies the IP address of the primary DNS (Domain Name Service) server.
Secondary DNS Server IP Address
3
This field specifies the IP address of the secondary DNS server. It is used as a backup to the Primary DNS
server address. If the Primary server is unavailable, the machine will contact the Secondary DNS server.
APIPA 3
The setting of On will cause the print server to automatically allocate a Link-Local IP address in the range
(169.254.1.0 - 169.254.254.255) when the print server cannot obtain an IP address through the BOOT
Method you have set (see BOOT Method on page 15). Selecting Off means the IP address doesn’t change,
when the print server cannot obtain an IP address through the BOOT Method you have set.
a Press Menu.
b Press a or b to select LAN.
Press OK.
To Next Page
Loading...
Need help?
General
