Control panel setup
23
3
c Press a or b to select TCP/IP.
Press OK.
d Press a or b to select APIPA.
Press OK.
e Press a or b to select On or Off.
Press OK.
(For MFC-680CN) Press d or c to select On or Off.
Press OK.
f Press Stop/Exit.
Setup Misc. 3
Ethernet 3
Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT
full or half duplex mode by auto negotiation.
100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half
Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset
(default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a Press Menu.
b Press a or b to select LAN.
Press OK.
c Press a or b to select Setup Misc..
Press OK.
(For MFC-680CN) Skip to e
d Press a or b to select Ethernet.
Press OK.
e Press a or b to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.
(For MFC-680CN) Press d or c to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.
f Press Stop/Exit.
To Next Page
Loading...
Need help?
General
