Brother MFC-7225N - Page 112

Confidential
5-43
NOTE: When re-assembling the halogen heater, put the halogen heater onto the fuser frame so
that the terminal of the heater harness is at the top, and secure the screws in the order
shown in the figure below.
(10) Remove the HR gear.
(11) Remove the two HR bush.
Halogen heate
r
Heater harness
Fuser frame
1
2
Heat rolle
r
HR
b
ush
Hooks
HR
b
ush
HR gea
r
Return the hook to the
original position.
HR gea
r
Return the hook to the
original position.