Brother MFC-730 - Using Remote Access Code; Exit Remote Operation; Change Answer Mode

203
Using Remote Access Code
1
Dial your MFC phone number from a
touch tone phone.
2
Enter your Remote Control Access Code
(159 ) after the beep.
3
The MFC signals the kinds of messages
received:
1 long beep — Fax message(s)
2 long beeps — Voice message(s)
3 long beeps — Fax and Voice message(s)
No beeps — no messages
4
After 2 short beeps, enter a command.
5
Press 9 0 to reset the MFC when you
finish.
6
Hang up.
15 6
Retrieve all faxes press 2, then
enter the number of remote fax
machine, and then # #. After the
beep, hang up and wait.
Erase all fax messages press 3.
Check Receiving Status
Press 9 7
then for Fax message, press 1.
Voice message, press 2.
1 long beep — received messages
3 short beeps — no messages
Change Answer Mode
Press 9 8
then for Message Manager (TAD mode),
press 1.
Fax/Telephone (F/T), press 2.
Fax Only, press 3.
Exit Remote Operation
Press 9 0 .
M ESSAGE M ANAGER
R EMOTE C ONTROL A CCESS C ARD
Using Remote Access Code
1
Dial your machine phone number from a
touch tone phone.
2
Enter your Remote Control Access Code
(159 ) after the beep.
3
Your machine signals the kinds of messages
received:
1 long beep — Fax message(s)
No beeps — no messages
4
After 2 short beeps, enter a command.
5
Press 9 0 to reset your machine when you
finish.
6
Hang up.
4
Change Answer Mode
Press 9 8
then for TAD, press 1.
Fax/Tel (F/T), press 2.
Fax, press 3.
Exit Remote Operation
Press 9 0.
Change Remote Access Code
1
Press Menu, 1, 8, 3.
2
Enter the 3-digit number. The cannot be
changed.
3
Press Set.
4
Press Stop to exit.
1
REMOTE CONTROL ACCESS CARD
(For MFC-730)
(For MFC-740)
➔
➔