Brother MFC-8420 - Connections

1 - 16 INTRODUCTION
Connections
1
Plug the telephone line cord from the wall socket into the back
of the MFC, in the socket labelled LINE.
2
Plug the telephone line cord from your external TAD into the
correct socket on the machine. (Make sure this cord is
connected to the TAD at the TAD’s telephone line socket, and
not its telephone socket.)
3
Set your external TAD to one or two rings. (The MFC’s Ring
Delay setting does not apply.)
4
Record the outgoing message on your external TAD.
5
Set the TAD to answer calls.
6
Set the Receive Mode to
External TAD
.
(See Choosing the Receive Mode on page 5-1.)
Do not connect a TAD elsewhere on the same phone line.
TAD
TAD
(Example
for the U.K.)