Brother MFC-9880 - Optional Accessories; Chapter 20 Optional Accessories; Memory Board

Optional Accessories 157
OPTIONAL
ACCESSORIES
20 Optional Accessories
Memory Board
The memory board is installed on the main controller board inside the machine. When you add the
optional memory board, it increases the performance for both fax and printer operations.
In general, the DIMM must have the following specifications:
Some DIMMs may not work with the machine. For more information, consult the dealer where you
purchased the machine. For the latest information from Brother visit: http://solutions.brother.com
Installing the Optional Memory Board
1 Disconnect the telephone line cord, unplug the machine power cord from the AC mains outlet,
and then disconnect the interface cable.
Model Name Optional Memory (recommended)
MFC-9880 with Standard Memory: 8MB 16 MB BUFFARO TECHNOLOGY 12323-0001
32 MB BUFFARO TECHNOLOGY 12324-0001
Type: 100 pin and 32 bit output
CAS Lantency: 2 or 3
Clock Frequency: 66 MHz or more
Capacity: 16 or 32 MB
Height: 46 mm (1.8 inches) or less
Parity: NONE
DRAM Type: SDRAM 4 Bank
• Unplug the power cord before installing (or removing) the memory board.