Configuring your machine for a wireless network (For MFC-9560CDW)
14
Configuration temporarily using a USB or network cable 3
You can temporarily use a USB cable or network cable when you configure your Brother machine in this
method.
You can remotely configure the machine from a computer that is also on the network using a USB cable
(A)
1
.
1
You can configure the wireless settings of the machine using a USB cable temporarily connected to a wired or wireless computer.
If there is an Ethernet Hub or Router on the same network as the WLAN access point (A), you can
temporarily connect the Hub or Router to the machine using a network cable (B). You can then remotely
configure the machine from a computer on the network.
A
B
A
To Next Page
Loading...
