Brother MFC-J415W

4
3
Copy settings 3
You can change the copy settings temporarily
for multiple copies.
The machine returns to its default settings
after 1 minute.
To change a setting, press a or b to scroll
through the copy settings. When the setting
you want is highlighted, press OK.
When you are finished choosing settings,
press Mono Start or Colour Start.
Note
You can save some of the settings that
you use most often by setting them as
default. These settings will stay until you
change them again. (See Setting your
changes as a new default on page 11.)
Stop copying 3
To stop copying, press Stop/Exit.
Changing copy speed and
quality 3
You can choose the copy quality. The factory
setting is Normal.
a Load your document.
b Enter the number of copies you want.
c Press a or b to choose Quality.
d Press d or c to choose Fast, Normal or
Best.
Press OK.
e If you do not want to change additional
settings, press Mono Start or
Colour Start.
Making copies 3
Fast Fast copy speed and lowest
amount of ink used. Use this
setting to save time (documents to
be proof read, large documents or
many copies).
Even if you set this option the copy
speed will be slower with
Ink Save Mode , Book Cop y or
Watermark Cop y turned on.
Normal Recommended setting for ordinary
print outs. Good copy quality with
adequate copy speed.
Best Use this setting to copy precise
images such as photographs. The
highest resolution and slowest
speed.