Brother MFC-J625DW - Setting Your Changes as a New Default; Restoring All Settings to the Factory Default

Printing photos from a memory card or USB Flash memory drive (MFC-J625DW and DCP-J725DW only)
47
8
f If you do not want to change additional
settings, press .
Press Start to print.
Note
The DPOF setting on your camera must
be turned off to use the Date Print
feature.
Setting your changes as a
new default 8
You can save the print settings you use most
often by setting them as the default settings.
These settings will remain until you change
them again.
a Press your new setting.
Repeat this step for each setting you
want to change.
b After changing the last setting, press
s or t to choose Set New Default.
c Press Set New Default.
d Press OK.
The LCD asks you again to confirm if
you set the change as the new default.
Press Yes.
e Press Stop/Exit.
Restoring all settings to the
factory default 8
You can restore the PhotoCapture settings
you have changed back to the factory default
for, Print Quality, Paper Type,
Paper Size, Brightness, Contrast,
Color Enhance, Cropping, Borderless
and Date Print.
a Press (PHOTO) or Photo.
Do one of the following:
 Press View Photos and press
s or t to display each photo. When
the photo you want to print is
displayed, press OK.
 Press Print All.
b Press Options.
c Press s or t to display
Factory Reset.
d Press Factory Reset.
e Press Yes to confirm.
f Press Stop/Exit.