Brother MFC-J6710DW - Restoring All Settings to the Factory Settings; Setting Your Changes as a New Default; Scan to a Memory Card or USB Flash Memory Drive; Glass Scan Size

Chapter 8
54
Setting your changes as a
new default 8
You can save the print settings you use most
often by setting them as the default settings.
These settings will stay until you change
them again.
a Press a or b and d or c to choose your
new setting.
Press OK.
Repeat this step for each setting you
want to change.
b After changing the last setting, press
a or b to choose Set New Default.
Press OK.
c Press 1 to choose Yes.
d Press Stop/Exit.
Restoring all settings to the
factory settings 8
You can restore the PhotoCapture settings
Print Quality, Paper Type,
Paper Size, Brightness, Contrast,
Color Enhance, Cropping, Borderless
and Date Print, that you have changed, to
the factory settings.
a Press a or b to choose
Factory Reset.
Press OK.
b Press 1 to choose Yes.
c Press Stop/Exit.
Scan to a memory card
or USB Flash memory
drive
8
Glass Scan Size 8
To scan a Letter, Legal, Ledger, or A3 size
document, you need to change the
Glass ScanSize setting. The default
setting is A4.
a Press (SCAN).
b Press a or b to choose
Scan to Media.
Press OK.
c Press a or b to choose
Glass ScanSize.
d Press d or c to choose A4, A3, Letter,
Legal or Ledger.
Press OK.
Note
• You can save the setting you use most
often by setting it as the default. (See
Setting your changes as a new default
on page 54.)
• This setting is only available for scanning
documents from the scanner glass.