Troubleshooting
133
B
Print Data Full The machine’s memory is full.
Press and delete the previously stored
secure print jobs.
Add optional memory (see Advanced
User's Guide).
Print Unable XX The machine has a mechanical
problem.
Do one of the following:
Press and hold down to turn the
machine off, wait a few minutes, and then
turn it on again (see Transferring your faxes
or Fax Journal report on page 136).
If the problem continues, contact Brother
customer service for support.
Registration
failed.
Registration failed. Press OK and try again.
Press and hold down to turn off the
machine.
Wait a few seconds, then turn it on again.
Perform the automatic colour registration
using the Touchscreen (see Colour
Registration on page 125).
Put in a new belt unit (see Replacing the
belt unit on page 95).
If the problem continues, contact Brother
customer service.
Rename the File There is already a file on the
USB flash drive with the same
name as the file you are trying
to save.
Change the file name of the file on the USB
flash drive or the file you are trying to save.
Replace Belt It is time to replace the belt
unit.
Replace the belt unit (see Replacing the belt
unit on page 95).
Replace Drum It is time to replace the drum
unit.
Replace the drum unit (see Replacing the drum
unit on page 89).
The drum unit counter was not
reset when a new drum was
installed.
Reset the drum unit counter by following the
instructions included with the new drum unit.
Replace Fuser It is time to replace the fuser
unit.
Contact Brother customer service or your local
Brother dealer to replace the fuser unit.
Replace Laser It is time to replace the laser
unit.
Contact Brother customer service or your local
Brother dealer to replace the laser unit.
Replace PF Kit MP
Replace PF Kit1
Replace PF Kit2
It is time to replace the paper
feeding kit.
Contact Brother customer service or your local
Brother dealer to replace the paper feeding kit.
Error Message Cause Action