Brother NX-2000 - Moving a Point

ENTERING STITCH DATA
130
h
Press .
i
If necessary, adjust any settings, such as the
stitch width and stitch length.
* Press to return to the stitch selection screen.
* Press to edit the custom stitch being created.
■ Moving a Point
a
Press or to move to the point
that you want to move.
* To move to the first point, press .
* To move to the last point, press .
* You can also move by using the touch pen.
b
Use to move the point.
Memo
• If you have entered points that are too close
together, the fabric may not feed properly. Edit the
stitch data to leave a larger space between points.
• If the stitch design is to be repeated and linked,
make sure that linking stitches are added so that the
stitch designs will not overlap.
a Linking stitches
a