Brother NX-2000 User Manual

SEWING THE STITCHES
Utility Stitches
91
3
■ Darning
Use darning stitches for mending and other applications.
Darning is sewn from the front of the presser foot to the back, as shown below.
a Reinforcement stitching
a
Select a stitch.
b
Set the scale on buttonhole foot “A” to the
desired length of the darning, and then attach
the buttonhole foot.
a Presser foot scale
b Finished measurement
c 7 mm wide (approx. 1/4 inch)
d 5 mm (approx. 3/16 inch)
c
Hold the outside frame of the buttonhole foot
toward the back with your finger, and then
lower the presser foot so that it aligns with
the area to be darned.
Stitch
Key
Stitch Name
Presser
Foot
Applications
Stitch width
[mm (inch)]
Stitch length
[mm (inch)]
Twin
Needle
Auto Manual Auto Manual
Darning
Darning of medium weight fabric
7.0
(1/4)
2.5 - 7.0
(3/32 - 1/4)
2.0
(1/16)
0.4 - 2.5
(1/64 - 1/16)
NO
Darning
Darning of heavyweight fabric
7.0
(1/4)
2.5 - 7.0
(3/32 - 1/4)
2.0
(1/16)
0.4 - 2.5
(1/64 - 1/16)
NO
a
a
Memo
The maximum length for darning is 28 mm (approx. 1-
1/16 inches).
a
b
c
d
Note
• Slide the outside frame of the buttonhole foot
backward as far as possible, making sure that there
is no gap behind the part of the foot marked “A”, as
shown in the illustration. If the buttonhole foot is not
slid back as far as possible, the darning will not be
sewn at the correct size.
• Pass the thread under the presser foot.

Brother NX-2000 Specifications

General

Brand	Brother
Model	NX-2000
Category	Sewing Machine
Language	English