Brother NX-2000 - Automatic Thread Cutting

USEFUL FUNCTIONS
44
c
Place the fabric under the presser foot with the
needle at the starting point of the stitching, and
then press the “Start/Stop” button. The
machine will automatically sew reverse stitches
(or reinforcement stitches), and then begin
sewing.
a Reverse stitches (or reinforcement stitches)
d
If the “Reverse/Reinforcement Stitch” button
is pressed, the machine automatically sews
reverse stitches (or reinforcement stitches),
then stops.
a Reverse stitches (or reinforcement stitches)
Automatic Thread Cutting
If the automatic thread cutting setting is selected before
sewing, the machine will automatically sew
reinforcement stitches (or reverse stitches, depending
on the selected stitch) and cut the thread when the
“Reverse/Reinforcement Stitch” button is pressed at the
end of stitching. This is useful when sewing buttonholes
and bar tacks.
a
Select a stitch.
b
Press to select the automatic thread
cutting setting.
→ The key appears as .
c
Place the fabric under the presser foot with the
needle at the starting point of the stitching, and
then press the “Start/Stop” button. The
machine will automatically sew reverse stitches
(or reinforcement stitches), and then begin
sewing.
a Reverse stitches (or reinforcement stitches)
Memo
If you press the “Start/Stop” button to pause sewing,
then press it again to continue, reverse stitches (or
reinforcement stitches) will not be sewn.
Memo
To cancel the automatic reverse/reinforcement
stitching setting, press again so that it appears
as .
Memo
The automatic thread cutting setting can be selected
when the automatic reinforcement/reverse stitching
setting is selected.
a
a
Memo
If you press the “Start/Stop” button to pause sewing,
then press it again to continue, reverse stitches (or
reinforcement stitches) will not be sewn.
a