Brother NX-2000 User Manual

LOWER/UPPER THREADING
Getting Ready
27
1
b
Guide the bobbin thread through the groove,
following the arrow in the illustration.
c
While lightly holding the upper thread, press
the “Needle Position” button twice to lower,
then raise the needle.
d
Gently pull the upper thread to pull up the
bobbin thread.
→ A loop of the bobbin thread comes out from the hole
in the needle plate.
e
Pull out about 100 mm of the bobbin thread,
and then pass it under the presser foot toward
the rear of the machine, making it even with
the upper thread.
a Upper thread
b Bobbin thread
f
Attach the bobbin cover.
Upper Threading
This section describes how to thread the machine and
the needle. The machine is marked with numbers that
indicate the threading order.
a
Turn on the machine.
b
Press the “Presser Foot Lifter” button to raise
the presser foot.
→ The upper thread shutter opens so the machine can
be threaded.
a
Upper thread shutter
Note
• Do not cut the thread with the cutter.
• Do not attach the bobbin cover.
a
b
CAUTION
• Be sure to thread the machine properly. Improper
threading can cause the thread to tangle and break
the needle, leading to injury.
• When using accessories not included with this
machine, attach the accessory to the machine after
threading the machine.
Memo
This machine is equipped with an upper thread
shutter, allowing you to check that the upper threading
is performed correctly.
7
8
10
11
12,13
9
14,15
2,16
3
1
4, 5
6
a

Brother NX-2000 Specifications

General

Brand	Brother
Model	NX-2000
Category	Sewing Machine
Language	English