• The bottom edge of the paper must be parallel to the roller.
• Only one side of the paper can be printed. Check the paper, and load it so that the smooth, thermal side
faces down.
• When loading A4-size paper, align the paper with the A4 Indicators on the printer. When loading Letter-
size paper, align the paper with the LTR Indicators on the printer.
Cut Paper
You can set the paper type to Cut Sheet, Roll, or Perforated Roll in the printer driver.
1. Use the printer's Tear Bar to cut the paper.
2. Pull one edge of the ejected paper up and towards the other edge diagonally.
a. Tear Bar
CAUTION
The Tear Bar is sharp. To avoid injury, do not touch the Tear Bar.
Related Information
• Set Up Your Printer
29
To Next Page
Loading...
