MAINTENANCE SCHEDULE
Maintenance is very important for keeping your vehicle in safe operating condition.
Proper maintenance is the owner's responsibility. The maintenance schedule
does not exempt the pre-ride inspection.
WARNING
Failure to properly maintain the vehicle according to the maintenance
schedule and procedures can make it unsafe to operate.
BREAK-IN INSPECTION - 1 000 KM (600 MI)
Replace engine oil and oil filter.
Inspect and clean the oil tank strainer.
Replace the Hydraulic Control Module (HCM) oil filter (SE5 model only).
Check engine coolant level.
Using BRP Utility and Diagnostic Software (B.U.D.S.), check fault codes and install
required updates.
Inspect throttle twist grip operation.
Check lighting system (brake light, hazard warning light, turn signal lights, position
lights, license plate light).
Check operation of control switches.
Inspect the drive belt condition and its tension. Adjust if required.
Check tightening torque of the rear wheel axle nut.
Check steering for abnormal play.
Lubricate front suspension arms.
Check parking brake operation. Clean and adjust
as required.
Check body panels looseness.
Check operation of storage compartment latches, hinges and key barrels.
120
______________
To Next Page
Loading...
