EasyManua.ls Logo

BRP Spyder RT - Diagnostic Guidelines; Will Not Shift into First Gear (SM5 Model); Will Not Shift into Neutral (SE5 Model); Will Not Shift (SE5 Model)

BRP Spyder RT
191 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DIAGNOSTIC GUIDELINES
NOTICE
If the vehicle must be
transported, do not have it towed
towing can seriously damage the
vehicle. Refer to
TRANSPORTING
THE VEHICLE
in this section for de-
tailed instructions.
Will not Shift into First
Gear (SM5 Model)
If the gearbox cannot shift into first
gear when vehicle is not moving:
1. Slowly release the clutch lever while
maintaining a light pressure down
on the shift lever.
2. When you feel the shift lever engag-
ing into first gear, pull in the clutch
lever.
Will not Shift into Neutral
(SE5 Model)
If the gearbox cannot shift into neutral
when vehicle is not moving:
1. The engine speed will be automat-
ically increased to approximately
1800 RPM then it will be brought
back to idle speed.
2. Up to 3 attempts will be done.
3. If it does not work, retrypressingup-
shift or downshift.
Will not Shift (SE5 Model)
Have your vehicle transported to the
nearest Can-Am roadster dealer.
Engine Does Not Start
ENGINE DOES NOT TURN OVER
1. Scrolling safety message on the
multifunction gauge not acknowl-
edged.
Read the safety message then
press the MODE button.
2. Engine stop switch in the OFF po-
sition.
Make sure that the engine stop
switch is in the ON position.
ENGINE DOES NOT TURN OVER
(cont’d)
3. Clutch lever not engaged (SM5
model).
Pull in and hold the clutch lever.
4. Ignition switch in the OFF posi-
tion.
Turn the ignition to the ON posi-
tion.
5. Battery dead or poor battery con-
nections.
Check the battery charge.
Recharge if necessary (see
MAINTENANCE PROCEDURES
subsection).
Check the battery connections in
the front storage compartment,
(see MAINTENANCE PROCE-
DURES subsection).
6. Blown fuse.
Check fuse condition (see HOW
TO REPLACE FUSES AND
LIGHTS in this section).
7. Transmission is in gear (SE5
model).
Depress brake pedal if transmis-
sion is in gear.
ENGINE TURNS OVER, BUT DOES NOT
START
1. Low fuel.
Fill the fuel tank. Refer to BASIC
PROCEDURES subsection.
2. Weak battery.
Check battery charge. Recharge
if necessary (see MAINTE-
NANCE PROCEDURES subsec
-
tion).
Check the battery connections in
the front storage compartment,
(see MAINTENANCE P
ROCE-
DURES subsection).
3. Engine managemen
t problem.
Check to see whet
her the engine
indicator lamp is ON while start-
ing. See an authorized Can-Am
roadster deal
er.
146
______________

Table of Contents

Related product manuals