MAINTENANCE PROCEDURES
Brakes
WARNING
New brakes will not operate at
their maximum efficiency until
their break-in is completed. Brak-
ing performance may be reduced,
so use extra caution. Brakes take
about300km(200mi)ofriding
with frequent braking to break-in.
For riding with infrequent braking,
allow extra time to break-in the
brakes.
Brake Fluid Level Verification
Use only DOT 4 brake fluid from a
sealed container.
Check the brake fluid level as follows:
1.Parkthevehicleonafirm,levelsur-
face.
2. Unlatch and lift the seat
OPENING
THE SEAT
.
rmo2010-001-013_b
1. Brake fluid reservoir
3. Check the brake fluid level in both
reservoirs, near the back of the seat.
They should both be above the MIN.
mark.
rmo2010-001-091_a
1. Brake fluid MAX. level mark
2. Brake fluid MIN. level mark
rmo2010-001-092_a
A. Operating range
4. Add fluid as required.
NOTE: Low brake fluid may indicate
leaks or worn brake pads. See an au-
thorized Can-Am roadster dealer.
Adding Brake Fluid
Remove the filler cap.
WARNING
Clean filler cap before removing.
UseonlyDOT4brakefluidfroma
sealed container.
1. Add fluid to MAX level.
NOTICE
Brake fluid can damage
painted surfaces or plastic parts.
Wipe up any spills.
2. Reinstall filler cap as follows:
2.1 Check that V slit is in good con-
dition.
2.2 Ensure diaphragm are prop-
erly positioned.
______________
139
To Next Page
Loading...
