PRIMARY CONTROLS
If operator does not downshift when
slowing down and engine RPM drops
below a threshold value, the gearbox
will automatically downshift to the
next available gear.
If the engine is started with gearbox in
gear, it will automatically shift to neu-
tral position.
NOTE: When a trailer is towed, the
trailer mode must be activated to adapt
the gear changes. Refer to
SETTING
THE TRAILER MODE
.
NOTICE
If the trailer mode is not
activated when towing a trailer, en-
gine components might be dam-
aged.
6) Brake Pedal
The brake pedal is in front of the right
footrest. Press it down to operate.
This pedal brakes all three wheels.
SM5 Models and SE5 Base Model
rmo2010-001-037_a
1. Brake pedal
2. Footrest
NOTE: When riding, make sure not
to lean your foot on brake pedal. Oth-
erwise, the engine management will
activatethelimphomemodetopro-
tect the braking system.
RT-S and RT LTD SE5 Models
rmo2013-005-015_a
NORMAL CONDITION
1. Brake pedal
2. Floorboard
A mechanism allows the floorboard to
lower if the pedal needs to be pressed
more than normal. If that occurs, push
on the rear portion of the floorboard un-
til it clicks and test the braking system.
rmo2013-005-016_a
LOWERED FLOORBOARD
1. Floorboard
If this condition persists or if you find
any braking system problems, refer to
an authorized Can-Am roadster dealer.
7) Parking Brake Switch
The parking brake switch is located
above the glove box. It allows to en-
gage or release the electric parking
brake.
14
______________
To Next Page
Loading...
