REQUIRED RIDING SKILLS AND PRACTICE EXERCISES
1
2
3
4
3
3
rmo2008-001-046_d
1. Start
2. Release throttle
3. Stop
4. Release throttle
Tips for Additional Practice
– Coordinate releasing the clutch
lever and applying the throttle to
start smoothly and to control your
acceleration.
5) Basic Turns
Purpose
– Get comfortable turning in a con-
trolled manner.
Directions
This exercise is similar to what you
did before, except that now instead
of
stopping for each turn, you will make
theturninthefrictionzone.
– Proceed down the straight away in
first gear. Ride a little farthe
rfrom
the cones so you can make a wide
arcing turn at the end of the straight-
away.
– As you approach the curve, slow
downtonomorethan8km/h
(5 MPH) by pulling in the clutch lever
and applying brake if needed.
– Hold the clutch lever in the friction
zone to maintain your low speed.
– Look in the direction of the curve.
– Turn the handlebar in the directionof
the curve, pulling on theinside hand-
grip and pushing on the outside. Be
careful not to change your hand po-
sition on the throttle.
– Leaning forward and into the curve
may help you turn the handlebar
more easily.
– Straighten your handlebar after the
turn and proceed down the straight-
away.
rmo2008-001-064
TYPICAL — RIDING POSTURE WHEN
TURNING
______
SAFE OPERA
TING INSTRUCTIONS
______
75
To Next Page
Loading...
