A high cooling water temperature reduces the life span! So take ongoing care to ensure sufficient
cooling of the device!
Do not place the device in direct sunlight and in close proximity to heat sources!
Although if the device has high IP protection, you should avoid placing it in direct contact with water
(rain, spurting water) if possible!
Under no circumstances should you put a low-resistance connection between the HV contacts, the
housing contacts and the LV contacts! This will lead to malfunctions and furthermore to the
destruction of the device!
Prevent any penetration of fluids into the device (e.g. during assembly work)! The penetration of fluids
will lead to a short circuit and subsequent damage to the device!
Under no circumstances should you operate the device if liquid is leaking in anywhere, refer
immediately to the company BRUSA Elektronik AG!
To Next Page
Loading...
