Technical data
and startup
6.12.1 Error definition
Errors invariably lead to shut down the inverter (Error mode). The resuming of operation is not taken place here
automatically.
Errors must always be cleared with the command DMC_ClrError. This can take place alternatively through a
hardware reset. You will find further information in the manual DMC5_ControlConcept.pdf.
You will find a list of possible error and warning messages along with their description in the manual
errors_and_warnings.pdf
The statuses of each error are periodically updated in CAN messages.
6.12.2 Warning message definition
Warning messages do not cause shut down of the inverter. They can however in many cases lead to a reduction in
output. The statuses of each warning message are periodically updated in CAN messages.
To Next Page
Loading...