Programming the Thermostat
28
3. Select one of these three options by pressing the
up or down button located to the right of the display.
You may also make your selection by pressing the
days button again. Select all days if your weekday
schedule is the same as your weekend schedule.
4. When you have selected one of the three options
(
all days, weekdays, weekends), press the period
button at the bottom of the thermostat. P1 will flash
on the display.
5. Press the Touch ‘N’ Go button –
home, away or
sleep – you want to use during period 1 (P1) from the
row of buttons just below the display. You will see the
triangle icon ( ) above the button selected. This
tells the thermostat whether you are home, away, or
asleep during P1. The thermostat will use the heating and cooling
temperature settings you’ve selected for that Touch ‘N’ Go button.
For example, if your heating temperature setting for
home is 72
degrees, the thermostat will keep the heat at 72 during P1.
6. Press the
period button twice. P2 will flash on the display.
To Next Page
Loading...
Need help?
General
