16
10.0 Powering Up
When the TCS-80X is switched on, by operating the power on-off switch
located on the rear panel, the internal circuitry carries out a series of routine
diagnostic tests. The display will show a series of numbers which will advise:
• The software version number currently fitted.
• Which interface option is fitted (TCS-804 only).
• If the BSS temperature probe is fitted (TCS-804 only)
Following the startup routine and screen display, the TCS-80X will
automatically resume the settings that were last selected, and show the last
selected delay before the previous switch-off. When first powered up, the
factory set defaults will be as shown below.
The internal memory automatically remembers all switch functions and
display readings when the unit is switched off, so it is not necessary to reload
level and delay information every time the unit is activated. The same applies
for the user programs, whose memory retains their contents indefinitely when
mains power is removed.
10.1 Default
Settings and
Display
• The TCS model number, plus a suffix ‘E’ if the internal memory has been
extended.
TEMP
HEADROOM
GAIN
DELAY
MIDI CHN
Tx. MODE
PGM MEMORY
MODE
LINKING
20°C
+10dBu
0dB
0mS
CH.1
Tr. Pr
P 1
MONO
None
Factory Default Settings:
Powering Up
To Next Page
Loading...