6
BSS Delays
2.0 What is special about BSS Delays?
Some of the features available within the series are:
• Stereo operation with two outputs per channel accurately linked, or dual
mono one-in/two-out.
• Mono one-in/four-out on the TCS-804. Mono one-in/three-out on the TCS-
803.
• Friendly rotary control knob for all parameter adjustments.
• Time or distance entry and display in milliseconds, feet, inches or metres.
• 10uS minimum delay steps.
• 105dB usable dynamic range includes full +20dBu headroom with fine
resolution at low signal levels. No companding or pre-emphasis means
superior high frequency performance.
• Exceptional phase linearity and HF accuracy from high sample rate and
gentle filtering.
• 12 non-volatile user programmable memories with remote recall via contact
closure or Midi.
• Maximum delay up to 2.6 seconds on TCS-804 in mono mode up to 1.3
seconds on TCS-803.
• Master/slave linking of multiple units by Midi.
• Delay time compensation for auditorium ambient temperature change. Fully
automatic on the TCS-804 with optional probe fitted.
• Electronic security lockout with optional mechanical security cover.
• Relay controlled signal bypass optionally available which is also linked into
fail-safe processor and power supply watchdog.
• Digital level control for both input headroom and output gain on the TCS-
804, gives automatic headroom compensation and allows remote control of
output levels and program storage.
Every TCS-80X is manufactured to the highest professional standards with a
robust steel case, high quality circuit boards and ICs, and high quality
components to provide reliable performance under the most demanding
conditions of the global sound-reinforcement environment. In common with
all other BSS equipment, the TCS-80X is subject to stringent quality control
procedures throughout the manufacturing process. Components are tested
against demanding acceptance criteria. Every completed unit is tested both
by measurement and in a listening test carried out by trained audio
professionals. To positively ensure reliability, all units are burnt-in for fifty
hours, before being tested.
To Next Page
Loading...