Transport, Delivery and Storage
5
ekr CON 600, ekr CON 600 net – Application with Wide Array Edge Sensors 19/39
5 Transport, Delivery and Storage
5.1 Transport
►
Transport the system components only in the original packaging
and in the position marked on the packaging.
►
Lift and put the transport goods down carefully.
5.2 Scope of Delivery
Obtain the scope of delivery from the delivery documents or con-
firmation of order.
5.3 Unpacking the Delivery
1. Check the outside of the packaging for damage and make a
complaint to the supplier if necessary.
2. Carefully open the packaging.
3. Check the delivery for completeness and visible damage.
4. Store the packaging for the event that components have to be
stored or transported.
5. If components are not installed immediately, store the compon-
ents in the original packaging, see chapter Storage, page 19.
5.4 Storage
NOTICE
Damage to the system caused by incorrect storage!
►
Never store the system and its components outdoors.
►
Adhere to the following storage conditions.
The system and components must be stored as follows:
■ In a well ventilated and dry room
■ In the original packaging
■ On palettes or on a shelf to protect against moisture on the
floor
■ Protected against dust and dirt (e.g. covered with film)
►
Observe the following Conditions:
Ambient Conditions Permissible values
Storage temperature 0 ... 75 °C (+32 ... +167 °F)
Air humidity 5 ... 90 % , non-condensing
To Next Page
Loading...
